Topic: Tables Author: Nelson Original Message Posted: Jun 22 2009 9:33AM Pete, I noticed that the balls are showing wear now ie. getting pretty slippery. Any chance you could switch them out with the new dark red ones. I noticed that they last longer and are more consistent than the older batches. Also, some of the rods have gook on them. I would lube them and then 1/2 hour later they'd start sticking again. Is it possible to clean out the rods/bearings with rubbing alcohol. The far table needs some leveling really bad, internally and externally. One leg isn't on the carpet because it's slanted. Can you put some levelers inside the the table as well to take away the funny roll a bit? If you need to order the new balls, can you switch out the side strips as well? Thank you. This thread does not accept replies because: The last post to this thread is more than 30 days old.